Minimum Spark Gap - Linhai 2004 ATV 260 Service Manual

CHAPTER 8 ELECTRICAL
*
4.lgnition spark gap
Disconnect the spark plug cap from the
spark plug
Connect the ignition tester 1 as shown.
2 Spark plug
Turn the main switch to "ON".
Check the ignition spark gap .
Check the spark by pushing the
starter switch, and increase the spark
gap until a misfire occurs.

Minimum spark gap:

6mm (0.24 in)
OUT OF
SPECIFICATION
OR
NO SPARK
5.Spark plug cap resistance
Remover the spark plug cap.
Connect the pocket tester (ΩX1 k) to
the spark plug cap.
NOTE:
When removing the spark plug cap.
do not pull the spark plug cap from
high tension cord.
Remove→Turning
counterclockwise
Connect→Turning clockwise.
Check the high tension cord
when connecting the spark
plug cap.
When connecting the spark plug cap,
cut the high tension cord about 5mm.
Spark plug cap
resistance:
5KΩ(20 )
℃
*
CORRECT
ATV SERVICE MANUAL 09.0
MEETS SPECIFICATION
The ignition system is not faulty.
Tester (+) lead →
Spark plug side
Tester (—) lead→
High tension cord side
OUT OF SPECIFICATION
Replace the spark plug cap
CHAPTER 8 ELECTRICAL PAGE.8- 10