Linhai 2004 ATV 260 Service Manual page 105

CHAPTER 3A ENGINE
1. Install:
Mechanical seal
Installation steps:
Apply the bond to the outside of the
mechanical seal.
Install the mechanical seal by using the
mechanical seal installer
bearing driver
2. Install:
Mechanical seal
Apply coolant to the outside of the mechanical
seal before installing.
NOTE:
Do not smear any oils or grease on the ring side
of the mechanical seal.
3. Inspect:
Mechanical sea , slip ring side
Inspect the slip ring side of the mechanical seal
and the impeller
Incorrect level → Reinstall.
4. Install:
Impeller shaft
Circ lip NEW
Installation steps:
Apply a small amount of grease to the impeller
shaft tip.
Install the impeller shaft while turning it. Use
care so that the oil seal is not damaged or the
spring does not slip off its position.
NOTE:
After installing the impeller shaft, check it for
smooth rotation.
5.Install:
O-ring NEW
6. Install:
Water pump housing
260/ 300 / 400 cc
NEW
and middle shaft
NEW
for level installation.
ATV SERVICE MANUAL09.0
CHAPTER 3 ENGINE PAGE. 3A- 66