Primary Sheave Assembly; Weight Inspection; Secondary Sheave Inspection - Linhai 2004 ATV 260 Service Manual

CHAPTER 3A ENGINE

WEIGHT INSPECTION

1. Inspect:
Weight minimum outside diameter
Cracks/Wear /Scaling /Chipping → Replace.
Out of specification → Replace
Weight out side diameter:
SECOMDARY SHEAVE INSPECTION
1. Inspect:
Secondary fixed sheave smooth operation
Secondary sliding sheave smooth operation
2. Inspect:
Torque cam groove
Wear /Damage → Replace.
3. Inspect:
Guide pin
Wear /Damage → Replace.
PRIMARY SHEAVE ASSEMEBLY
1. Clean:
Primary sliding sheave face
Primary fixed sheave face
Collar
Weight
Primary sliding sheave cam face
NOTE:
Remove any excess grease.
2. Install:
Weight
Collar
NOTE:
Apply molybdenum disulfide grease to all of the
outside of the weight and install.
Apply lightweight lithium-soap base grease to
the inside of the collar.
260/ 300 / 400 cc
20.0 mm
<Limit: 19.5mm>
ATV SERVICE MANUAL09.0
CHAPTER 3 ENGINE PAGE. 3A- 46