Carburetor Idle Adjustment; Transmission Oil Inspection - Linhai 2004 ATV 260 Service Manual

CHAPTER 3C ENGINE 100/125/150/200
SERVICE MANUAL09.0
NOTE:
Since the crankshaft
decompression, the
counterclockwise, or it is impossible to adjust the
valve.
3. Measure the valve clearance by using a feeler
gauge.
Valve clearance specification:
Intake valve
Exhaust valve 0.04—0.06mm
4. To adjust valve clearance, loosen the locknut,
turn the adjuster in or out with valve adjusting
tool until specified clearance is obtained.
Measure the valve clearance once more after
the locknut is tightened.

3.3.4 Carburetor idle adjustment

1. Start the engine and let it warm up for several
minutes.
2. Turn the idling adjusting screw in or out until
specified idling speed is obtained.
3. Idling speed specification: 1700±170rpm
4. If the idling speed is unstable or it is not smooth
when accelerating the throttle slightly, adjust the
fuel quantity adjusting screw, which is better to
be done by professionals.

3.3.5 Transmission oil inspection

ATV100/150)
1. Stand the engine on a level surface.
2. Remove the oil filler cap after the engine stops.
3. Check if the oil level reaches the lower edge of
the filing orifice.
4. Always use the same type of oil when refilling.
The type used for this engine: SAE15W/40SG
5. Tighten the oil filler cap.
6. If the oil needs replacing, warm up the engine
and then stop. Remove the drain bolt to drain
the oil. And fill the case with new oil.
7. The oil capacity of a new engine: 110ml The
top filling for replacement: 90ml
CHAPTER 3C ENGINE
is equipped with
fan cannot be rotated
0.04—0.06mm;
(for MINI
PAGE.3C - 4 -
a