Sharp MX-2300 G Service Manual page 355

c. Resist roller (Drive)
1) Remove the resist roller unit.
2) Remove the spring and the E-ring. Remove the JAM release
handle.
3) Remove the parts. Slide the resist roller (Drive) to the front
side. Remove the parallel pin, the PS gear, and the E-ring from
the resist roller (Drive).
3
2
2
4
d. Resist detection
1) Remove the resist roller unit.
2) Remove the PS stay, then remove the resist detector.
1
1
5
2
MX-2300/2700 N/G PAPER TRANSPORT SECTION F – 3
e. Resist roller (Idle)
1) Remove the resist roller unit.
2) Remove the PS stay.
3) Clean the resist roller (idle).