Sharp MX-2300 G Service Manual page 120

SIMULATION NO.05 02
TEST
HEATER LAMP LOAD SETUP
HL_UM
HL_US
5-3
Purpose : Operation test/check
Function (Purpose) : Used to check the operation of the scanner
lamp and the circuit.
Section : Optical (Image scanning)
Item : Operation
Operation/Procedure
1) Press [OC COPY LAMP] button on the touch panel.
2) Press [EXECUTE] button.
The target lamp is lighted for 10 sec.
SIMULATION NO.05 03
TEST
COPY LAMP CHECK
OC COPY LAMP
5-4
Purpose : Operation test/check
Function (Purpose) : Used to check the operation of the dis-
charge lamp and the related circuit.
Section : Process
Item : Operation
Operation/Procedure
1) Select the item to be checked with the buttons on the touch
panel.
2) Press [EXECUTE] button.
The selected discharge lamp is lighted.
DL_K Discharge lamp K
DL_C Discharge lamp C
DL_M Discharge lamp M
DL_Y Discharge lamp Y
SIMULATION NO.05-04
TEST
DISCHARGE LAMP CHECK
DL_K DL_C
0
CLOSE
HL_LM
HL_ALL
EXECUTE
1/1
0
CLOSE
EXECUTE
1/1
Same control
0
CLOSE
DL_M DL_Y
EXECUTE
1/1
MX-2300/2700 N/G SIMULATION 7 – 14
6
6-1
Purpose : Operation test/check
Function (Purpose) : Used to check the operations of the paper
transport system, the transfer system, the
fusing system (clutches and solenoids) and
the control circuits.
Section : Paper transport section (Transport, paper
exit)
Item : Operation
Operation/Procedure
1) Select the item to be checked with the buttons on the touch
panel.
2) Press [EXECUTE] button.
The selected load operation is performed.
When [EXECUTE] button is pressed, the operation is termi-
nated.
Transport/ PFM Transport motor
imaging
RRM Resist motor
POMF (*) Paper exit motor normal rotation
POMR (*) Paper exit motor reverse rotation
FUM Fusing motor
CPFM Cassette paper feed motor
OSM Shifter motor
WTNM Waste toner drive motor
CPFC Cassette vertical transport clutch
1TURC Primary transfer separation clutch
PCSS Process control shutter solenoid
LSUSS1 LSU shutter solenoid 1
LSUSS2 LSU shutter solenoid 2
Paper feed CLUM1 Cassette 1 lift-up motor
CPUC1 Cassette 1 paper feed clutch
CLUM2 Cassette 2 lift-up motor
CPUC2 Cassette 2 paper feed clutch
MPUC Manual paper feed clutch
MPFS Manual feed take-up solenoid
MPGS Manual feed gate solenoid
(*): For the same loads displayed separately depending on normal
rotation and rotation, if they are selected together, normal rotation
is performed.
In addition, if the load is rotating, reverse rotation is not accepted
until the operation is stopped.
SIMULATION NO.06 01
TEST
FEED OUTPUT CHECK
PFM RRM
FUM CPFM
1TURC PCSS
CPUC1 CLUM2
0
CLOSE
POMF POMR
OSM CPFC
WTNM
CLUM1
CPUC2 MPUC
EXECUTE 1/2