Sharp MX-2300 G Service Manual page 124

9
9-2
Purpose : Operation test/check
Function (Purpose) : Used to check the operations of the sen-
sors and detectors in the duplex section
and its control circuit.
Section : Duplex
Item : Operation
Operation/Procedure
The sensor and detector operation conditions are displayed.
The active sensors and detectors are highlighted.
DSW_ADU ADU transport open/close detection
APPD1 ADU transport path detection 1
APPD2 ADU transport path detection 2
SIMULATION NO.09 02
TEST
ADU SENSOR CHECK
DSW_ADU APPD1
9-3
Purpose : Operation test/check
Function (Purpose) : Used to check the operations of the loads
in the duplex section and the control cir-
cuits.
Section : Duplex
Item : Operation
Operation/Procedure
1) Select the item to be operation tested with the buttons on the
touch panel.
2) Press [EXECUTE] button.
The selected load operation is performed.
When [EXECUTE] button is pressed, the output is terminated.
ADUM_L ADU motor lower
SIMULATION NO.09-03
TEST
ADU LOAD CHECK
ADUM_L
0
CLOSE
APPD2
1/1
1/1
0
CLOSE
EXECUTE 1/1
MX-2300/2700 N/G SIMULATION 7 – 18
10
10-1
Purpose : Operation test/check
Function (Purpose) : Used to check the operations of the toner
motor and the related circuit.
Section : Process (Developing)
Item : Operation
Operation/Procedure
* Before execution of this simulation, remove the toner cartridges.
1) Select the item to be checked with the buttons on the touch
panel.
2) Press [EXECUTE] button.
* The selected load operation is performed for 10 sec.
* When [EXECUTE] button is pressed, the operation is termi-
nated.
TNM_K Toner motor K
TNM_C Toner motor C
TNM_M Toner motor M
TNM_Y Toner motor Y
SIMULATION NO.10-01
TEST
TONER MOTOR ACTIVATION
TNM_K
TNM_C
13
13--
Purpose : Clear/cancel (Trouble etc.)
Function (Purpose) : Used to cancel the self-diag "U1" trouble.
Section : FAX
Item : Trouble
Operation/Procedure
1) Press [EXECUTE] button.
2) Press [YES] button to execute cancellation of the trouble.
SIMULATION NO.13
TEST
U1 TROUBLE CANCELLATION
ARE YOU SURE?
CLOSE
TNM_Y
TNM_M
EXECUTE 1/1
0
CLOSE
YES NO
EXECUTE
0