Sharp MX-2300 G Service Manual page 187

Category Item
SEGMENT 4 digits Quantity of
or less detection
setting adjustment
5 digits Text on
or more mesh ON/
setting OFF (Auto/
Manual
mode)
(Initial screen)
SIMULATION NO.46 33
TEST
COLOR AUTO MODE ADJUSTMENT(ACS 4DIGIT UNDER)
A 0
THCLMK_1
A: 0
B 0 THCLBK_1
C 0 ACSMSK_1
0 9
D 0 THCLMK_2
(On the screen, [NEXT] is pressed.)
SIMULATION NO.46-33
TEST
COLOR AUTO MODE ADJUSTMENT(ACS 5DIGIT OVER)
PRESENT 000010000
NEW
TH_ACS5 ENLARGE
Content
Display
AW BKUCR_ACTA (–
THROUGH
99%)
OFF
ON
AX BKUCR_ACTA
THROUGH
(100% – 199%)
OFF
ON
AY BKUCR_ACTA
THROUGH
(200% –)
OFF
ON
A MESH_CHECK1 ON
OFF
B MESH_CHECK2 ON
OFF
C MESH_CHECK3 ON
OFF
D MESH_CHECK4 ON
OFF
E THED3A(*1)
F THED3B(*1)
0
CLOSE
OK
BACK NEXT
0
CLOSE
SET
BACK NEXT
MX-2300/2700 N/G SIMULATION 7 – 81
Set range/Number of digits
– 99%
100% – 199%
200% –
Check button for investigation
[(Auto) text on mesh]
Check button for investigation
[(Auto) Text mesh (Under 1,
Line 1)
Check button for investigation
[(Auto) Text mesh (Under 2,
Line 1)
Check button for investigation
[(Auto) text print]
THED3A (Text on mesh ON/
OFF)
THED3B (Text on mesh ON/
OFF)
46-36
Purpose : Adjustment
Function (Purpose) : Used to perform the fine adjustment of 2-
color (Red, Black) copy.
Section : –
Item : Image quality
Operation/Procedure
1) Select a category to be set.
* When [RANGE] (red judgment range), [COEFFICIENT] (out-
put color coefficient) button is pressed to select each cate-
gory, the selected button is highlighted and the set items of
the selected category are displayed.
* Only one button can be selected. The selected button is
highlighted.
In the initial state, [RANGE] is selected.
2) Select the set item with [↑] and [↓] buttons.
The highlighted set value is switched and the value is dis-
played in the setting area.
* If there is any item over [↑], an active display is made and
item is shifted.
If there is no item over [↑], the display grays out and the
operation is invalid.
If there is any item under [↓], an active display is made and
item is shifted.
If there is no item over [↓], the display grays out and the
operation is invalid.
3) Enter the set value with 10-key.
* Press [C] key to clear the entered values.
4) When [OK], [↑], [↓] button, [COLOR], or [BLACK] key is
pressed, the currently entered data are saved to EEPROM and
RAM.
Default
Screen
value
0 – 0 0
2
1
2
0 – 0 0
2
1
2
0 – 0 0
2
1
2
0 – 0 0
1
1
0 – 0 0
1
1
0 – 0 0
1
1
0 – 0 0
1
1
0 – 65535 1000
0 – 65535 1000
type
A
B