Sharp MX-2300 G Service Manual page 121

6-2
Purpose : Operation test/check
Function (Purpose) : Used to check the operations of each fan
motor and its control circuit.
Section : Other
Item : Operation
Operation/Procedure
1) Select the item to be checked with the buttons on the touch
panel.
2) Press [EXECUTE] button.
The selected load operation is performed.
When [EXECUTE] button is pressed, the operation is termi-
nated.
POFM Paper exit cooling fan motor (* POFM_U, POFM_F, and
POFM_R are driven at the same time.)
OZFM Ozone fan motor
PSFM Power cooling fan motor
SIMULATION NO.06 02
TEST
FAN LOAD SETUP
POFM
PSFM
6-3
Purpose : Operation test/check
Function (Purpose) : Used to check the operations of the primary
transfer unit and the related circuit.
Section : Process (Transfer)
Item : Operation
Operation/Procedure
1) Press [EXECUTE] button.
2) The load operation is started. (Separation operation: BLACK
→ COLOR → FREE Stops at each position for 5 sec.) During
the operation, the current position is displayed.
BLACK Black mode position
COLOR COLOR mode position
FREE Drum separation position
SIMULATION NO.06 03
TEST
TRANSFER LOAD CHECK
:
POSITION
0
CLOSE
OZFM
EXECUTE 1/1
Black mode position
→ COLOR mode position
→ Drum separation position
→ Shift to the black mode
position is repeated.
0
CLOSE
EXECUTE
1/1
MX-2300/2700 N/G SIMULATION 7 – 15
7
7-1
Purpose : Setting
Function (Purpose) : Used to set the operating conditions of
aging.
Section : Other
Item : Operation
Operation/Procedure
1) Select the target to be set with buttons on the touch panel.
2) Press [EXECUTE] button.
The machine is rebooted in the aging mode.
The contents set with this simulation are retained until the
power is turned OFF.
AGING Aging operation setup
INTERVAL Intermittent setup
MISFEED DISABLE JAM detection enable/disable setup
FUSING DISABLE Fusing operation enable/disable setup
WARMUP DISABLE Warm-up disable setup
DV CHECK DISABLE DV unit detection enable/disable setup
SHADING DISABLE Shading disable setup
CCD GAIN FREE CCD gain adjustment free setup
SIMULATION NO.07 01
TEST
AGING TEST SETTING
AGING
MISFEED DISABLE
WARMUP DISABLE
SHADING DISABLE
7-6
Purpose : Setting
Function (Purpose) : Used to set the intermittent aging cycle.
Section : Other
Item : Operation
Operation/Procedure
1) Enter the intermittent aging cycle (unit: sec) with 10-key.
2) Press [OK] button.
The time entered in procedure 1) is set.
Item Item
A CYCLE TIME(SEC)
SIMULATION NO.07-06
TEST
INTERVAL AGING CYCLE TIME SETUP
A 3
CYCLE TIME(SEC)
A:
3
1 900
0
CLOSE
INTERVAL
FUSING DISABLE
DV CHECK DISABLE
CCD GAIN FREE
EXECUTE
1/1
Set range Default value
1 to 900 3
0
CLOSE
OK