Sip Refer Transfer - Panasonic KX-NCP500 Feature Manual

16.1.3 SIP Refer Transfer

–
Call Transfer without Announcement
For details, refer to the Quick Reference Guide of the KX-HGT100.
SIP Video Phone
Video phone calls can be established between SIP extensions with video phone capabilities.
Conditions
[General]
•
This PBX supports SIP devices that use RFC 3261, 3264, 3310, 2327, or 4028.
•
Some SIP phones may not be compatible with this PBX.
•
Before a SIP extension can be used with the PBX, the IP address of the MPR card, password, and extension
number must be assigned on the SIP extension and on the PBX.
For details on how to register, refer to the Information on IP Networking Guide.
•
When registering the SIP extension, the user ID must be the extension number of the SIP extension.
•
When a SIP extension uses the Call Hold feature, the target call is put on Consultation Hold.
[SIP Video Phone]
•
When making a SIP video phone call, call features such as Call Transfer are not available.
Installation Manual References
KX-NCP500/KX-NCP1000
3.4.1 Virtual Cards
KX-TDE100/KX-TDE200
3.4.1 Virtual Cards
KX-TDE600
3.4.1 Virtual Cards
PC Programming Manual References
3.17 [1-1] Slot—Card Property - Virtual SIP Extension
3.18 [1-1] Slot—Port Property - Virtual SIP Extension Port
3.19 [1-1] Slot—Port Property - Virtual SIP Extension Port—Connection Command
16.1.3 SIP Refer Transfer
Description
If enabled through system programming, calls transferred to a SIP CO line will be transferred using the SIP
service provider's Transfer feature instead of the PBX's.
The following types of transfer are available:
Attended Transfer
Blind Transfer
310 Feature Manual
Transfer is completed after announcing the transferred party.
From the extension user's perspective, this is the same as Call
Transfer with Announcement (® 3.1.11 Call Transfer).
Transfer is completed immediately after dialing the transfer
destination's number.
This is similar to Call Transfer without Announcement (® 3.1.11 Call
Transfer), except that the transferrer does not hear even a ringback
tone; the transferred call is connected directly to the destination.
Document Version 2013-05