•
After a sensor has been activated, the PBX will ignore any further alerts from the same sensor for the
duration specified by a timer. This timer can be set separately for each sensor.
•
As long as the previous sensor call is still being performed, any further alerts from the same sensor are
ignored.
•
The assigned sensor name and/or number are shown on the display of PTs and PSs when a sensor call
is received.
•
If the destination of a sensor call has set FWD, the sensor call will be redirected to the FWD destination.
However, if the FWD destination is not supported as the destination of a sensor call (e.g., an outside party),
the call will be received at the original destination. (® 6.1.6 FWD (Call Forwarding))
•
The following features cannot be used when a sensor call is received:
–
Alternate Receiving—Voice (® 9.1.13 Intercom Call)
–
Hands-free Answerback (® 8.1.1 Hands-free Answerback)
–
Consultation Hold/Call Hold (® 3.1.22 Consultation Hold, ® 3.1.5 Call Hold)
–
Call Transfer (® 3.1.11 Call Transfer)
–
Executive Busy Override (® 5.1.3 Executive Busy Override)
•
Sensor call information is output on SMDR.
Installation Manual References
KX-NCP500/KX-NCP1000
3.7.1 OPB3 Card (KX-NCP1190)
3.7.3 EIO4 Card (KX-TDA0164)
3.9.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
KX-TDE100/KX-TDE200
3.7.1 OPB3 Card (KX-TDA0190)
3.7.3 EIO4 Card (KX-TDA0164)
3.9.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
KX-TDE600
3.9.1 OPB3 Card (KX-TDA0190)
3.9.3 EIO4 Card (KX-TDA0164)
3.11.1 Connection of Doorphones, Door Openers, External Sensors, and External Relays
PC Programming Manual References
3.44 [1-1] Slot—OPB3 Card Property
→
Input Signal Decision Time
→
Input Signal Detection Reopening Time
4.5 [2-3] Timers & Counters—Miscellaneous—
4.17 [2-8-3] Ring Tone Patterns—Call from Others—
7.7 [5-5] External Sensor
Document Version 2013-05
External Sensor—Ring Duration
External Sensor—Ring Tone Pattern Plan 1–8
5.1.9 External Sensor
Feature Manual
111