Extension Port Configuration - Panasonic KX-NCP500 Feature Manual

5.1.7 Extension Port Configuration

5.1.7 Extension Port Configuration
Description
There are three types of extension ports, used to connect digital proprietary telephones (DPTs), analog
proprietary telephones (APTs), single line telephones (SLTs), Cell Stations (CSs), DSS Consoles, and Voice
Processing Systems (VPS) to the PBX. The devices which can be connected to each type of port are listed
below.
a.
DPT Port: DPT, DSS Console, Panasonic VPS which supports DPT (Digital) Integration, and PT-interface
CS (e.g., KX-TDA0158)
b.
SLT Port: SLT and Panasonic VPS which supports DTMF Integration
c.
Super Hybrid Port: DPT, APT, SLT, DSS Console, Panasonic VPS, and PT-interface CS
EXtra Device Port (XDP):
A Super Hybrid port can be used as an XDP port, allowing two telephones (a DPT and an SLT) to be connected
to the same port of the PBX. This XDP port can be used in one of the following modes:
Mode
Parallel Mode
XDP Mode
Conditions
•
Automatic Detection on Super Hybrid Port
A DPT, SLT, or PT-interface CS connected to a Super Hybrid port can be detected automatically without
any programming. An APT connected to a Super Hybrid port can be detected automatically when XDP
mode has been disabled.
•
A DSS Console or a Panasonic VPS which supports DPT (Digital) Integration can also be connected with
an SLT in XDP mode.
•
APT and SLT in Parallel Mode
An APT and an SLT can also be connected to a Super Hybrid port and used in parallel mode.
•
Digital XDP
A DPT can be connected to another DPT and act as an independent extension with its own extension
number. (® 13.1.2 Paralleled Telephone)
•
Wireless XDP Parallel Mode
A PS can be used in Wireless XDP Parallel mode with a wired telephone.
(® 20.1.5 Wireless XDP Parallel Mode)
•
DSS Console and Paired Telephone Assignment
When a DSS Console is connected, a PT must be paired with the DSS Console through system
programming.
PC Programming Manual References
3.24 [1-1] Slot—Port Property - Extension Port
6.18 [4-3] DSS Console—
108 Feature Manual
The DPT and an SLT share the same extension number so that
they can act as one extension. The SLT uses the extension data
(extension number, Class of Service [COS], etc.) of the DPT. (®
13.1.2 Paralleled Telephone)
The DPT and SLT have different extension numbers and act as
independent extensions. To use XDP mode, XDP mode must be
enabled for the port through system programming. (®
13.1.2 Paralleled Telephone)
Pair Extension
Description
Document Version 2013-05