Panasonic KX-NCP500 Feature Manual page 286

13.1.26 Private Network Features—VoIP (Voice over Internet Protocol)
Conditions
[General]
•
Some QSIG services are available. (® 13.1.20 PRIVATE NETWORK FEATURES—QSIG)
•
Toll Restriction (TRS) settings apply to calls rerouted to public CO lines. When making a call using System
Speed Dialing, regular TRS settings are applied, even if the TRS Override by System Speed Dialing feature
is enabled. (® 17.1.6 TRS (Toll Restriction))
[Common Extension Numbering for Multiple PBXs]
•
The KX-NCS3910, KX-NCS4910 or KX-NCS4950 (Activation Key for Software Upgrade to Enhanced
Version) is required to use this feature.
•
System programming is required to enable this feature.
•
If the called extension does not exist at the called PBX, the next PBX in the same gateway group is called
automatically.
•
The Routing to Operator setting in system programming must be disabled to use this feature.
•
To use this feature, all PBXs in the IP network have to be KX-NCP or KX-TDE series PBXs, version 3.0000
or later.
Installation Manual References
KX-NCP500/KX-NCP1000
3.4.1 Virtual Cards
KX-TDE100/KX-TDE200
3.4.1 Virtual Cards
3.5.5 IP-GW4E Card (KX-TDA0484)
3.5.6 IP-GW16 Card (KX-TDA0490)
KX-TDE600
3.4.1 Virtual Cards
3.7.5 IP-GW4E Card (KX-TDA0484)
3.7.6 IP-GW16 Card (KX-TDA0490)
PC Programming Manual References
3.7 [1-1] Slot—Port Property - Virtual IP Gateway Port
3.39 [1-1] Slot—Port Property - IP-GW Port (KX-TDE series only)
4.10 [2-6-2] Numbering Plan—Quick Dial—
work
11.1 [9-1] TIE Table
12.6 [10-4] Miscellaneous—
programmed.)
Feature Manual References
1.1.3 ARS (Automatic Route Selection)
13.1.15 PRIVATE NETWORK FEATURES
286 Feature Manual
Use quick dial for rerouting to public CO when TIE line does not
Intercept—Routing to Operator - No Destination (Destination is not
Document Version 2013-05