Maintenance; Battery Replacement; Rc Handset; Rc Battery Box - Valor 500FS Installer And Owner Manual

MAINTENANCE

Battery replacement.

Please note: In order to ensure maximum battery life and optimal performance,
we recommend that only 'Long Life' alkaline type replacement batteries are
used.
Handset (RC only)
The remote control handset is battery powered. To
replace the battery, remove the rear compartment
cover from the remote control handset. To do this
push the cover towards the bottom of the handset.
Remove the existing battery. Fit two 'AAA' size
batterys in to the handset and replace the cover.
Remote battery box (RC only)
The gas valve and receiver box are battery powered (6-Volt). To replace the four 'AA'
batteries it will be necessary to remove the visual baffle.
NOTE: the four 'AA' batteries do not get fitted into
the reciever unit but instead only into the remote
battery box on the connecting cable.
The front of the visual baffle is held in place with
two M5 knurled screws. Unscrew both anti
clockwise by hand to remove them holding the
visual baffle gently pull forward to remove. The
battery pack is now accesable, lift it up and out
carefully. Open and slide the battery compartment cover clear. Remove the existing
batteries. Fit four Alkaline 1.5 Volt 'AA' size batteries. It is important that the +ve and
-ve symbols on the battery match those of the illustration inside the battery holder.
NEVER connect a 9-Volt battery directly to the cable of the remote battery box.
Replace and secure the cover, place the batter pack back from where it was removed
from. (LHS of the burner assembly) and replace the visual baffle and two screws.
Spark ignition generator (FS only)
The spark ignition generator are battery powered (1.5-Volt). To replace the single 'AA'
battery required it is not necessary to remove the visual
baffle but you may do so if easier access required. At the
front of the electronic spark generator there is a removable
circular battery cover. Unscrew the cover in an
anticlockwise direction.
Remove any protective film from the new battery if
applicable and place into the generator. The negative (-)
terminal should go in first. The battery is marked with (+).
Screw back on the cap.
©
Page 56
GDC Group Ltd. SEPT 2016