Table of Contents
Advertisement
Battery replacement.
1. The electronic ignition unit is located at the base of
the fire on the right hand side (See figure 5).
2. To access the electronic ignition unit battery the fascia
will have to be removed. The fascia securing screws are
located at the bottom rear of the fascia. Remove the
securing screws from both sides of the fascia.
3. The fascia can now be removed. To do this firmly hold
the fascia sides, gently pull the bottom of the fascia
forward whilst lifting the fascia upward and forward.
Place the fascia in a safe place.
4. Remove the battery and discard.
5. Remove any protective film from the replacement
battery and place into the electronic ignition unit. The
negative ( - ) and positive ( + ) terminals are marked on
the unit.
6. Place the fascia over the engine. Make sure
that the top rear of the fascia locates fully into
the 'U' shaped notch of the engine back panel
(See figure 6).
7. Secure the fascia using the two screws
previously removed.
Regular maintenance.
In order to achieve and maintain high levels of
personal safety and performance efficiency, it
is essential that the opening at the back of the
fire and the flue are kept clear of any form of
obstruction. It is possible that deposits of
mortar or soot could fall and accumulate
causing the flue to be blocked or restricted and
so preventing proper clearance of dangerous
exhaust fumes.
In the United Kingdom it is the law that a landlord must have any gas appliance, flue
and pipework which is situated in a tenant's premises checked for safety at least
every twelve months by a competent person (GAS SAFE REGISTER operative). We
recommend that all gas appliances and their flues, wherever situated, are checked
annually.
©
GDC Group Ltd. 2011
OWNER GUIDE
MAINTENANCE
Page 39
Figure 5. Fitting the battery
Figure 6. Fascia top location
(Shown at rear for clarity)
Advertisement
Chapters
Table of Contents
