Table 1.3 Status And Meanings Of Each Led (Controller) - Fujitsu ETERNUS DX60 S3 Operating Instructions Manual

Chapter 1 Component Name/LED Name
1.1 Controller Enclosures
2. DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
When the controller enclosure is a 2.5" type, this port is not used.
3. LAN (RMT) port
These are the RJ-45 connectors to connect LAN cables.
4. LAN (MNT) port
These are the RJ-45 connectors to connect LAN cables.
5. Host interface (CA#0)
This interface is used for connecting a controller with a server.
6. Host interface port (FC port) (CA#0, Port#0)
These are the Dual LC connectors to connect FC cables.
7. Host interface port (FC port) (CA#0, Port#1)
These are the Dual LC connectors to connect FC cables.
8. Host interface port (iSCSI port) (CA#0, Port#0)
These are the RJ-45 connectors to connect LAN cables.
9. Host interface port (iSCSI port) (CA#0, Port#1)
These are the RJ-45 connectors to connect LAN cables.
10. Host interface port (SAS port) (CA#0, Port#0)
These are the miniSAS (SFF-8088) connectors to connect miniSAS cables.
11. Host interface port (SAS port) (CA#0, Port#1)
These are the miniSAS (SFF-8088) connectors to connect miniSAS cables.
12. IDENTIFY/SCU READY LED
13. DI (OUT) LINK/FAULT LED
14. LAN ACT LED
15. LAN LINK LED
16. READY/FAULT LED
17. LINK/FAULT LED
18. FAULT LED
19. LINK LED
20. CA#0 FAULT LED
21. MASTER LED
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 1.3 Status and Meanings of Each LED (Controller)

LED name
IDENTIFY/SCU READY
LED status
(blinks blue)
(blinks green)
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Meaning
As ordered via ETERNUS Web GUI or ETERNUS CLI, the installation
location of the controller is identified.
System Capacitor Unit (SCU) is charging.
19
P3AM-9012-01ENZ0