Figure 1.18 I/O Module; Table 1.7 Status And Meanings Of Each Led (I/O Module) - Fujitsu ETERNUS DX60 S3 Operating Instructions Manual

Chapter 1 Component Name/LED Name
1.2 3.5" Type Drive Enclosure
Figure 1.18 shows the I/O module.

Figure 1.18 I/O Module

2 3
1. DI (IN) port
These ports are used to connect between enclosures.
2. DI (IN) LINK LED
3. DI (IN) FAULT LED
4. DI (OUT) port
These ports are not used.
5. READY LED
6. IDENTIFY LED
7. FAULT LED
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 1.7 Status and Meanings of Each LED (I/O Module)

LED name
DI (IN) LINK
DI (IN) FAULT
READY
IDENTIFY
FAULT
Table 1.7
1 4
LED status
(green)
(amber)
(blinks amber)
(green)
(blinks blue)
(amber)
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
shows the status and meanings of each LED.
Meaning
The link between the DI (IN) port and the source port has been
established.
The link between the DI (IN) port and the source port is in error
status.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
The I/O module is in normal status.
The installation location of the I/O module is identified according
to the instruction that is issued from ETERNUS Web GUI or ETER-
NUS CLI.
The I/O module is in error status.
26
5
6
7
P3AM-9012-01ENZ0