About This Manual - Fujitsu ETERNUS DX60 S3 Operating Instructions Manual

Fujitsu would like to thank you for purchasing our FUJITSU Storage ETERNUS DX60 S3 Disk storage system
(hereinafter referred to as ETERNUS DX).
The ETERNUS DX is designed to be connected to Fujitsu servers (Fujitsu M10, PRIMEQUEST, or PRIMERGY) or
non-Fujitsu servers.
This manual describes the operation management and maintenance of the ETERNUS DX.
This manual is intended for use of the ETERNUS DX in regions other than Japan.
Please carefully review the information outlined in this manual.

About This Manual

Organization
This manual is composed of the following six chapters:
• "Chapter 1 Component Name/LED Name" (page 12)
This chapter provides component names of the ETERNUS DX.
"Chapter 2 Basic Operation" (page 30)
•
This chapter explains how to turn on and off the ETERNUS DX and how to operate the buttons on the oper-
ation panel.
"Chapter 3 Storage System Monitoring" (page 40)
•
This chapter describes the status monitoring of the ETERNUS DX.
"Chapter 4 Component Expansion/Function Enhancement " (page 44)
•
This chapter explains how to install drives and drive enclosures in the ETERNUS DX.
"Chapter 5 Maintenance" (page 68)
•
This chapter describes maintenance once the ETERNUS DX starts to be operated.
• "Chapter 6 Troubleshooting" (page 69)
This chapter explains troubleshooting when errors occur on the ETERNUS DX.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
3
Preface
First Edition
December 2014
P3AM-9012-01ENZ0