Fujitsu ETERNUS DX60 S3 Operating Instructions Manual page 56

Chapter 4 Component Expansion/Function Enhancement
4.2 Installing Additional Drive Enclosures
Insert the M5 screws in the 1st and 6th holes on the front rack pillars above the base line and in
the 2nd and 5th holes on the rear rack pillars above the base line to fasten the rack rails.
Sixth screw
(M5 screw)
First screw
(M5 screw)
Fifth screw
(M5 screw)
Second screw
(M5 screw)
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
(4)
Install the drive enclosure in the rack.
Front view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
Rear view of drive enclosure
[Left]
2U
Bottom position of
drive enclosure
Rack rail
Do
When installing or removing the drive enclosure to or from the rack,
•
make sure that the sides and the bottom of the drive enclosure are held
by two or more people. Failure to do so may cause injury.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
[Right]
Sixth screw
(M5 screw)
First screw
(M5 screw)
[Right]
Fifth screw
(M5 screw)
Second screw
(M5 screw)
56
Step (1).
P3AM-9012-01ENZ0