Table 3 Status And Meanings Of Each Led (Controller) - Fujitsu ETERNUS DX60 S3 Operation Manual

1. Component Names and LED Names
Controller Enclosures
The LEDs turn on or blink to indicate the statuses that are listed below.

Table 3 Status and Meanings of Each LED (Controller)

LED name
IDENTIFY/BBU FAULT
DI (OUT) LINK/FAULT
LAN ACT
LAN LINK
READY/FAULT
LINK/FAULT
FAULT
LINK
CA FAULT
MASTER
FUJITSU Storage ETERNUS DX60 S4, ETERNUS DX60 S3 Hybrid Storage Systems Operation Guide (Basic)
LED status Meaning
As ordered via ETERNUS Web GUI or ETERNUS CLI, the installation
(blinks blue)
location of the controller is identified.
The battery is in error status.
(amber)
The link between the DI (OUT) port and the destination port has
(green)
been established.
•
(amber)
•
The ports to connect the cables are indicated. This occurs while a
(blinks amber)
drive enclosure is being added.
Data is being sent or received via the LAN port.
(blinks green)
The link between the LAN port and the destination has been es-
(green)
tablished.
The controller is in normal status.
(green)
An error has occurred during startup.
(blinks green)
•
(amber)
•
(blinks amber)
The link between the host interface port (FC or SAS) and the des-
(green)
tination port has been established.
The host interface port (FC or SAS) is in error status.
(amber)
The link between the host interface port (iSCSI) and the destina-
(green)
tion port has been established.
The host interface port (iSCSI) is in error status.
(amber)
The host interface is in error status.
(amber)
The controller is set as a Master CM.
(green)
16
Copyright 2018 FUJITSU LIMITED
The link between the DI (OUT) port and the destination port is
in error status.
The ports to remove the cables between enclosures from are in-
dicated. This occurs while a drive enclosure is being added.
The controller is performing the initial setup after the power is
turned on.
The controller is in error status.
P3AM-9012-08ENZ0