Fujitsu ETERNUS DX60 S3 Operating Instructions Manual page 37

Chapter 2 Basic Operation
2.1 Powering On and Off
For other procedures, refer to the related manuals.
1
Press and hold the Power switch of the controller enclosure for four seconds or more.
Power switch
The READY LED is turned off.
Press the Power switch only once. If the Power switch is pressed again between the time of the
READY LED turning off and the POWER LED turning off, the ETERNUS DX power may turn on.
2
The ETERNUS DX power is turned off.
The POWER LED is turned off.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
37
P3AM-9012-01ENZ0