Powering On - Fujitsu ETERNUS DX60 S3 Operating Instructions Manual

Chapter 2 Basic Operation
2.1 Powering On and Off
2.1.3

Powering On

This section explains how to turn on the ETERNUS DX.
To turn on the ETERNUS DX, perform the following procedure.
Via the power switch
•
Press the Power switch to turn on the ETERNUS DX.
The following methods can be used to turn the power on by linking with the server.
Power Synchronized Unit
•
Use the power synchronized unit to turn on the ETERNUS DX.
Wake On LAN
•
Use the Wake On LAN function to turn on the power.
Before turning on the ETERNUS DX, make sure that the main line switches of the power distribution units
and the PSU switches on the power supply units of the ETERNUS DX are "ON". Do not turn the main line
switches of the power distribution units and the PSU switches on the ETERNUS DX to the OFF position.
After turning the power on, it takes approximately three minutes for the ETERNUS DX to become READY
•
(i.e. the READY LED turns on). If an error is detected in a component during the initial power-on diag-
nostics, it may take up to ten minutes for the ETERNUS DX to be in a READY state. This should be taken
into consideration for scheduled operations.
Before turning the server on, check that the ETERNUS DX and the network devices that connect the
•
ETERNUS DX and the server are all in READY status.
If the server is turned on while any of these devices are not in READY status, the server may not be able
to recognize the ETERNUS DX.
To turn on the ETERNUS DX by linking with the server, the server must wait until the ETERNUS DX is in a
•
READY state.
If the Auto Power function is enabled via ETERNUS Web GUI or ETERNUS CLI, the ETERNUS DX is automat-
•
ically turned on when power is supplied to the ETERNUS DX.
If the Power Resume function is enabled via ETERNUS Web GUI or ETERNUS CLI, the ETERNUS DX is auto-
•
matically turned on after the power is restored.
• After power-off, wait for about one minute before turning power on again.
This section explains how to use the Power switch to turn on the ETERNUS DX.
For other procedures, refer to the related manuals.
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
35
P3AM-9012-01ENZ0