Fujitsu ETERNUS DX60 S3 Operating Instructions Manual page 20

Chapter 1 Component Name/LED Name
1.1 Controller Enclosures
LED name
DI (OUT) LINK/FAULT
LAN ACT
LAN LINK
READY/FAULT
LINK/FAULT
FAULT
LINK
CA FAULT
MASTER
LED status
(green)
(amber)
(blinks amber)
(blinks green)
(green)
(green)
(blinks green)
(amber)
(blinks amber)
(green)
(amber)
(green)
(amber)
(amber)
(green)
FUJITSU Storage ETERNUS DX60 S3 Disk storage system Operation Guide (Basic)
Copyright 2014 FUJITSU LIMITED
Meaning
The link between the DI (OUT) port and the destination port has
been established.
The link between the DI (OUT) port and the destination port is in
error status.
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
Data is being sent or received via the LAN port.
The link between the LAN port and the destination has been es-
tablished.
The controller is in normal status.
An error has occurred during startup.
• The controller is performing the initial setup after the power is
turned on.
• The controller is in error status.
The link between the host interface port (FC or SAS) and the des-
tination port has been established.
The host interface port (FC or SAS) is in error status.
The link between the host interface port (iSCSI) and the destina-
tion port has been established.
The host interface port (iSCSI) is in error status.
The host interface is in error status.
The controller is set as a Master CM.
20
P3AM-9012-01ENZ0