10 Servicing
New Electronic Expansion
Valve Coil for Replacement
10.9.14 Removing Horizontal Louver
For RPK-(0.8-1.5)FSN(H)3M
Do not remove the horizontal louver when removing the drain pan. Removing the horizontal louver will result in component
failures.
For RPK-(2.0-4.0)FSN(H)3M
Do not lose the bearings for each shaft at the right, middle, left and far left.
1 Open the upper and lower horizontal louver slightly.
2 Slightly bend the upper horizontal louver and pull it in the direction of the arrow (A) to remove the shaft at the far right
from the drain pan.
3 As slightly bending the center pole at the right side of the drain pan in the direction of the arrow (B), pull the upper
horizontal louver in the direction of the arrow (C) to remove the shaft at the right from the drain pan.
Far Left
Left
Middle
Shaft
Shaft
Shaft
Upper Louver
(A)
Lower Louver
4 Pull out the upper horizontal louver in the direction of the arrow (D) to remove it.
387
SMGB0077 rev.0 - 01/2013
Projection Portion
on Valve Body
Right
Far Right
Shaft
Shaft
Drain Pan
Far Right Shaft
Drain Pan
Detent of Electronic
Expansion Valve Coil
(A)
Rotation Direction
Wiring Outlet of
Expansion Valve Coil
Bearing
(B)
(C)
Lower Louver
Center Pole
at Right Side
of Drain Pan
(D)
Upper Louver
10
Upper Louver