Hitachi RCI-1.0FSN3 Service Manual page 378

10 Servicing
Attaching flat panel.
Insert completely the left and right arm shafts of flat panel into
the holes along the guide at the front panel. Ater the flat panel is
attached completely, insert the catches for air filter to fix it.

For RPK-(2.0-4.0)FSN(H)3M
1 Remove the air filter according to the "Removing Air Filter." chapter.
2 Open the flat panel fully and push the right arm shaft inward. After the shaft is removed from the front panel, pull the
flat panel frontward with the right arm shaft slightly pushed inward and then remove the flat panel.
3 Remove 3 bushes and then 3 screws. Pull the lower side of the front panel (2 portions) forward to release the catches.
Use a slotted screwdriver when the catches are difficult to release.
C A U T I O N
Take special care not to be injured by the heat exchanger fins.
4 Remove the front panel carefully so that it does not touch the horizontal louver attached to the air outlet. Slightly lift
the front panel up to release the catches (4 portions) on the upper side of the unit. Then pull the front panel forward
to remove it.
N O T E
When releasing the catches, snap sound is heard. This is the sound made when the catches are released
and so there are no safety concerns.
Push the shaft
toward arrow
direction
Flat panel
5 When mounting the front panel, be careful that it does not touch the horizontal louver. Paying attention to both sides of
the panel, put the catches (four portions) on the upper side of the unit into the holes on the panel. Then push the lower
side of the panel (2 portions) to fasten the catches.
366
SMGB0077 rev.0 - 01/2013
Remove this part
from the hole
When using a slotted
screwdriver, insert it
into the gap and push
the catches downwarads.
Flat Panel
Holes for Catches
Screw
Bush
Guide at
Front Panel
Hole
Front Panel
Drain Pan Projection
Portion for Catches
Catches on Lower Side
of Front Panel