Hitachi RCI-1.0FSN3 Service Manual page 71

2 Unit installation
Lift up the air filter, detach the catches from the indoor
unit and remove the air filter downward.
After the right arm shaft is pushed inward and the
shafts are removed from the front panel, pull the flat
panel frontward while the right arm shaft is slightly
pushed inward.
Attaching flat panel for RPK-(2.0-4.0)FSN3M
Insert completely the left and right arm shafts of flat panel into
the holes along the guide at the front panel. After the flat panel is
attached completely, insert the catches for air filter to fix.
C A U T I O N
When removing front panel, do not apply an excessive force by hitting, etc. It may break the unit body.
59
SMGB0077 rev.0 - 01/2013
Push the shaft
toward arrow di-
rection.
Flat panel
Front panel
Flat panel
Remove this part
from the hole.
2
Guide at
front panel
Hole