Hitachi RCI-1.0FSN3 Service Manual page 379

10 Servicing
N O T E
Make sure that there is no gap nor lap between the front panel and the left side of the drain pan. If there is a gap there, an
air leakage and dew condensation may occur and the dew may drop on the front panel.
6 Tighten 3 screws and attach 3 bushes. And then mount the air filter.
7 Insert completely the arm shafts of left and right side of the panel into the holes along the guide of the front panel. After
the flat panel is attached properly, close the flat panel.
Drain Pan
Make sure there is no lap between the
front panel and the left side of the
drain pan.
Attaching flat panel
Insert completely the left and right arm shafts of flat panel into
the holes along the guide at the front panel. After the flat panel is
attached completely, insert the catches for air filter to fix.
367
SMGB0077 rev.0 - 01/2013
Put 4 catches on the upper
side of the unit into the holes
on the front panel.
Drain Pan Projection
Portion for Catches
Catches on Lower Side
of Front Panel
Flat panel
Guide at
front panel
Hole
Front panel
10