Filters - Hitachi RCI-1.0FSN3 Service Manual

2 Unit installation

2.11.2 Filters


Filter box
For RCI-FSN3 indoor units: B-160H2
The dimensions of the filter box are shown in the following figure.
Corner Frame
(Galvanized Steel Plate)
Counter Mark
(Refrigerant Pipe Side)
Fixing Plate
(4 Portions)
When the filter box is installed, the total height of the unit increases by approximately 55 mm. Therefore, pay attention to
the installation space.
Bear in mind that the size before compression is 10 mm, but the size is reduced after compression to 5mm.
< Service Space >
Installation
Height
83
SMGB0077 rev.0 - 01/2013
549
(Opening Dimension)
U-Shaped Hook
(2 Portions)
Filter Holder
(Resin)
700
(Installation Dimension)
800
840
Indoor Unit
Packing
Direction
to remove
the filter.
Air Inlet Grille
(Attached with Air Panel)
Model
1.0 - 2.5
3.0 - 6.0
Insulation
(Polyethylene)
10 (Before Compression)
20 50
5 (After Compression)
Polystyrene
55 (Installation Height)
Air Filter
Long Life Filter
(Attached with Air Panel)
Filter Box
Air Panel
Ceiling
Dimensions
a b
291 236
341 286
Packing
(EPDM)
2