Removing Drain Pan - Hitachi RCI-1.0FSN3 Service Manual

10 Servicing

10.9.9 Removing Drain Pan

Take care when removing the drain pan, as water may have collected in the drain pan.

For RPK-(0.8-1.5)FSN(H)3M
Do not remove the horizontal louver. Otherwise, some component may be damaged.
1 Remove the front panel according to the "Removing Front Panel" chapter.
2 Remove the electrical box according to the "Removing Electrical Box" chapter.
3 Release the catches fixing the drain pan.
i. 1.0HP (3 portions) :
ii. 1.5HP (4 portions) :
Then draw the drain pan in the direction of the arrow in the figure below to remove it.
N O T E :
Before removing the drain pan, check that the drain hose is not fixed. If the drain hose is firmly fixed, the drain pan cannot
be removed.
4 When mounting the drain pan, mount it in the reverse procedure. Make sure that the catches fixing the drain pan,
mentioned in the procedure (3), are fastened.
Positions of Fixing Catches for Drain Pan
(Example: 1.5HP)
Fixing Catch (C)
(A)
Center Pole
of Drain Pan
Pull the drain
pan frontward.
Fixing Catch
for Drain Pan
375
SMGB0077 rev.0 - 01/2013
(A)×1, (B)×1 and (C)×1
(A)×2, (B)×1 and (C)×1
Fixing Catch (A)
(B)
Fixing Catch for Drain Pan
Release the catch in the direction
of the arrow.
Direction for Removing Drain Pan
Fixing Catch (B)
2. Pull the drain pan
frontward and
downward.
(C)
Release the catch in the direction
of the arrow.
1. Draw the drain
pan frontward.
10
Fixing Catch
for Drain Pan