Hitachi RCI-1.0FSN3 Service Manual page 70

2 Unit installation
Removal of the front panel for RPK-(0.8-1.5)FSN(H)3M
Hold both sides of flat panel and open it fully.
Lift up the air filter, detach the catches from the indoor unit and
remove the air filter downward.
After the right arm shaft is expanded outward and the shafts are
removed from the front panel, pull the flat panel frontward while
the right arm shaft is slightly expanded outward.
Attaching flat panel for RPK-(0.8-1.5)FSN(H)3M
Insert completely the left and right arm shafts of flat panel into
the holes along the guide at the front panel. After the flat panel is
attached completely, insert the catches for air filter to fix.
Removal of the front panel for RPK-(2.0-4.0)FSN3M
Hold both sides of flat panel and open it fully.
58
SMGB0077 rev.0 - 01/2013
Remove this part
Expand the shaft
from the hole.
toward arrow di-
rection.
Flat panel
Guide at
front panel
Front panel
Flat panel
Hole