Power Windows - Toyota RAV4 EE Owner's Manual

Power windows

The windows can be operated with the
switch on each door. The passengers'
windows can also be controlled by the
switches on the driver's door.
Vehicles without smart entry and start sys-
tem—The power windows work when the
engine switch is set at the "ON" position.
Vehicles with smart entry and start sys-
tem—The power windows work when the
"ENGINE START STOP" switch is set at
IGNITION ON mode.
Key off operation: If the either front door
is closed, they work for 45 seconds even
after the engine switch (vehicles without
smart entry and start system) or the
"ENGINE START STOP" switch (vehicles
with smart entry and start system) is
turned off. They stop working when the
either front door is opened.
OPERATING THE DRIVER'S WINDOW
Use the switch on the driver's door.
Normal operation: The window moves as
long as you hold the switch.
To open: Lightly push down the switch.
To close: Lightly pull up the switch.
Automatic operation: Push the switch
completely down or pull it completely up,
and then release it. The window will fully
open or close. To stop the window part-
way, lightly move the switch in the oppo-
site direction and then release it.
RAV4_EE
KEYS AND DOORS
Jam protection function: During automat-
ic closing operation, the window stops and
opens half way if something gets caught
between the window and window frame.
If the window receives a strong impact,
this function may work even if nothing is
caught.
When the power window does not close
normally
If the jam protection function is operating
abnormally and a window
closed, perform the following operations
using the power window switch on the
driver's door.
Vehicles without smart entry and start sys-
tem—After stopping the vehicle, the win-
dow can be closed by holding the power
window switch in the one−touch closing
position while the engine switch is turned
to the "ON" position.
Vehicles with smart entry and start sys-
tem—After stopping the vehicle, the win-
dow can be closed by holding the power
window switch in the one−touch closing
position while the "ENGINE START STOP"
switch is turned to IGNITION ON mode.
If the window still cannot be closed even
by carrying out the operation explained
above, initialize the function by performing
the following procedure.
1. Hold the power window switch in the
one−touch closing position. Continue
holding the switch for a further 6 sec-
onds after the window has closed.
2. Hold the power window switch in the
one−touch opening position. Continue
holding the switch for a further 2 sec-
onds after the window has opened
completely.
3. Hold the power window switch in the
one−touch closing position once again.
Continue holding the switch for a fur-
ther 2 seconds after the window has
closed.
If you release the switch while the window
is moving, start again from the beginning.
Finish
67
cannot be