Toyota RAV4 EE Owner's Manual page 190

180
LIGHTS, WIPERS AND DEFOGGER
High−Low beams—For high beams, turn
the headlights on and push the lever away
from you (position 1). Pull the lever to-
ward you (position 2) for low beams.
The headlight high beam indicator light
(blue light) on the instrument panel will
tell you that the high beams are on.
Flashing the high beam
(position 3)—Pull the lever all the way
back. The high beam headlights turn off
when you release the lever.
You can flash the high beam headlights
even when the headlight switch is off.
RAV4_EE
TURN SIGNALS
To signal a turn, push the headlight/
turn signal lever up or down to position
1.
Vehicles without smart entry and start sys-
tem—The engine switch must be set at
the "ON" position.
headlights
Vehicles with smart entry and start sys-
tem—The "ENGINE START STOP" switch
must be set at IGNITION ON mode.
The lever automatically returns after you
make a turn, but you may have to return
it by hand after you change lanes.
To signal a lane change, move the lever
up or down to the pressure point (position
2) and hold it.
If the turn signal indicator lights (green
lights) on the instrument panel flash faster
than normal, a front or rear turn signal
bulb is burned out. See "Replacing light
bulbs" on page 532 in Section 7−3.
Finish