Sending A Fax Using The Platen Glass - Konica Minolta 7013 Operating Instructions Manual

Sending a fax using the platen glass

1
Press / to change to Fax mode.
COPY FAX
2
If there's a document in the
ADF
3
Open the platen cover.
4
Place the document face down on the platen glass and align it with the doc-
ument scale on the right, then gently close the platen cover.
The document should be aligned to the right front corner.
Important: Gently close the platen cover so that you don't catch your
hands, possibly injuring them.
When a thick document, such as a book, is on the platen glass,
do not press strongly from the top of the platen cover. This
may break the platen glass and cause an injury.
5
Press to select the document size, A4, A5
DOCUMENT SIZE
6
Adjust resolution and contrast if necessary.
, remove it.
or F4.
7
Enter the fax number.
Also, enter any access codes necessary, just as you would for a regular phone
call. (Example: Enter 9 to "dial out" from an office telephone system, or 1 for
long-distance.)
Press Start
919725552009_
8
Press .
START
By pressing , you've just given your machine a command. In turn, your
START
machine gives this action a command number as it scans the fax document.
This command number appears on the first line of the LCD for a few seconds:
== Command:01 ==
You'll need this command number to cancel the transmission or to print a
stored document (see pages 2.7–2.8).
Then your machine will scan the document into the memory.
While your machine scans the document, the
919725552009
A4 NextDoc Mem100%
9
When the scanning is done, the
Start Scan → → NextDoc
→ → Start
Tx Start
If you want to send more pages, proceed to step 10.
Otherwise, press to start the transmission, and skip to step 11.
START
10
Place the next page, then press
Note: If necessary, select the document size (see step 5).
To send any more pages, repeat steps 9-10.
Otherwise, press to start the transmission, and skip to step 11.
START
11
Now, everything is up to the machines — yours and the one you're dialing.
When it makes contact, your machine transmits the stored document from
memory.
Important: If you want to cancel a transmission while scanning the docu-
ment, press the
If you want to cancel a transmission in progress, use the Review
Commands function. See "Reviewing or canceling commands,"
page 2.7.
will show:
LCD
will show:
LCD
to start scanning.
NEXT DOC
key.
STOP
Basic operation
2.5