Konica Minolta 7013 Operating Instructions Manual page 91

Advanced features
Programming an F-Code transmission
For this operation to work, two things must be true:
• You must know how the remote fax is using each F-Code box to which you're
transmitting — for example, as a security box or a relay box. Different fax manu-
facturers may use slightly different terms, but the concepts are the same.
• You must know the remote fax's
which you want to transmit.
To program an F-Code transmission into a programmable one-touch key:
1
Press Program key, , 3, 0, 1,
A
grammable one-touch number available:
Select Program No.
P2:No Number Stored
Note: If P2 appears on the
number for P1. You can see what you programmed into P1 by press-
ing , if you want. For example, if you set P1 for storing of the polling
document, you will see:
Select Program No.
P1:Polling Document
Press to go back to the programmable one-touch key you want to
enter.
Note: To erase a programmable one-touch key, see page 3.48.
2
Press the key that you want to program or change. Here, we've selected P2.
Select Program No.
P2:No Number Stored
Note: If your previous command for this key was for an F-Code transmis-
sion and you want to keep this key programmed for an F-Code
transmission, use these instructions to make changes. But if you want
to assign this key to a completely different operation (for a delayed
transmission, for example), then you first must erase the stored com-
mand before programming the new one.
3
If you want to select a different programmable one-touch key than the one
that appears on the , press that key now.
LCD
4
Press . The asks which operation you want to program into the pro-
ENTER LCD
grammable one-touch:
Type :Communication
/ /Enter
3.40
- sub-address and password for each box to
ITU T
. The shows the first empty pro-
ENTER LCD
, it means that you have already entered a
LCD
Note: If changing a previously stored command, skip to step 7.
5
Press until "Communication" appears.
Type :Communication
/ /Enter
6
Press . The now shows either:
ENTER LCD
P2:Fax#/Advan.Func.
_
7
Use the numeric keypad to enter the number exactly as your machine should
dial it, including whatever codes your phone system requires. The number can
be up to 40 characters in length:
P2:Fax#/Advan.Func.
9-5550629_
Your display can show only 20 characters at a time. To view characters beyond
those 20, press to scroll to the left or
Important: Do not press
ENTER
8
Now, while you still can see the fax number on the
three times and then press
FUNCTIONS
Enter Sub-Address
_
9
Use the numeric keypad to enter the
you want to send the document. Here, we've entered 123456:
Enter Sub-Address
123456_
10
Press . The shows:
ENTER LCD
Enter Password
_
Note: If there isn't a password for this box, press
11
Use the numeric keypad to enter the appropriate
Here, we've entered 654321:
Enter Password
654321_
When finished, press .
ENTER
P2:Fax#/Advan.Func.
9-5558743_
or
to scroll to the right.
.
, press
LCD ADVANCED
. The shows:
ENTER LCD
- sub-address for the box to which
ITU T
, then skip to step 13.
ENTER
- password for the box.
ITU T