Using The Bypass Tray - Konica Minolta 7013 Operating Instructions Manual

Basic operation
Helpful Tip: You can set the copy reduction or enlargement ratio to "Auto".
(See "Setting copy auto," page 4.7.) If the "Auto" is set and you
set the document size by pressing
automatically reduce or enlarge the original size (you entered)
to fit on the paper size you selected.
5
As needed, set the following:
• Select document type and adjust image contrast
• Enter the number of copies
6
Press .
START
Note: To reset the copy parameter to default setting, press
Note: To stop the copying, press

Using the bypass tray

When you need to use a size of paper not currently loaded in your machine's paper
cassette(s), or when you want to use a special type of paper (such as transparency
film), use the bypass tray.
Important: If loading transparency (OHP) film into the bypass tray, be sure that
the sheet is designed for laser printers and not for copiers. Also, be
sure that the film does not have a paper backing and/or a leading
strip. If it does, remove the paper backing and/or strip before insert-
ing. Only film should go in, not film with any backing or strip.
1
Either insert the document in the
2
Set the paper in the bypass tray.
See the table of "Acceptable paper size and cassette capacity" on page 1.8 and
"Loading paper in bypass tray" on page 1.10 for more information.
Note: Place the original document in the same orientation as the paper in
the paper source.
3
The machine will select the bypass tray for the paper
source and the will show the default paper size you
LCD
selected in step 6 on page 1.10.
If you want to change it, proceed to step 4.
Otherwise, skip to step 10.
Copy Ready
[ A4 ] A4
2.14
DOCUMENT SIZE
COPY RESET
.
STOP
or place it on the platen glass.
ADF
1
100%
4
Press
BYPASS
, the machine
Set Bypass Ppr:A4
5
If your recording paper in the bypass tray is A4, A5
Otherwise, skip to the step 7.
Note: When you use transparency film, skip to step 8 and select "OHP" in
6
Press
chosen A5 :
.
Set Bypass Ppr:A5
Skip to step 9.
7
Press
Set Bypass Ppr:Other
Then press
Set Bypass Ppr:Exe
8
Press
chosen Postcard:
Set Bypass Ppr:Post
9
Press
ENTER
10
If necessary, select desired resolution, contrast, reduction/enlargement ratio.
11
Press
START
to change the paper size. The
LCD
/ /Enter
step 9.
or until your desired recording paper size appears. Here, we've
/ /Enter
or until "Other" appears.
/ / /Enter
or . You will see:
ENTER
/ / /Enter
or until your desired recording paper size appears. Here, we've
/ / /Enter
.
to begin the copying process.
will show:
or F4, proceed to step 6.