Table of Contents
Advertisement
22 | HDZ Series 1080p IP PTZ User Manual
Installing a Ceiling Mount (Indoor Only)
The HDCM1 ceiling mount weighs 4.0 lb. (1.8 kg) and can be installed directly to a load-bearing
ceiling. The mount has a maximum load rating of 26.0 lb. (11.7 kg) and is for indoor use only.
See the documentation included with the ceiling mount for more information on securing the
mount to the mounting surface.
To install a ceiling mount:
1.
Ensure that the ceiling can support the combined
weight of the camera and the mount (should
support at least 8.8 lb. [4.0 kg]).
2.
Make a cable entry hole in the ceiling.
3.
Feed the cables through the mount, leaving
approximately 1 ft (0.3 m) extending past the end
of the mount (see
Note
If you are using the recommended safety cable
for additional security, feed it through the
mount and attach one end to the camera eyelet
and the other end to the building structure (see
Figure
2-1).
4.
Attach the mount to the ceiling using appropriate
hardware.
5.
Screw the indoor mount kit to the bracket.
6.
Connect the cables to the camera (see
Connecting the Cables on page
using a Micro SD card, install it before
connecting the cables.
Note
Check that the eyelet safety cable connection is
secure, and carrying all of the load of the
camera after making all cable connections.
7.
Attach the camera to the mount kit and then
tightly fix the security screw on the top of the
camera.
www.honeywell.com/security
Figure 2-2
HDCM1 Ceiling Mount Installation
Figure
2-2).
25). If you are
Example of
Indoor Dome
Ceiling Mount
Installation
Feed
cables
through the
mount kit
Tightly fix the
screw at the top of
the camera
Screw the
mount kit into
the ceiling
mount
Attach the
camera
body to
the mount
kit
Advertisement
Table of Contents
