Enabling Irdp Globally; Enabling Irdp On An Individual Vlan Interface - HP ProCurve Series 4100GL Management And Configuration Manual

messages from other routers at the same time. The interval on each IRDP-
enabled routing switch interface is independent of the interval on other
IRDP-enabled interfaces. The default maximum message interval is 600
seconds. The default minimum message interval is 450 seconds.
■ Preference - If a host receives multiple Router Advertisement messages
from different routers, the host selects the router that send the message
with the highest preference as the default gateway. The preference can be
a number from -4294967296 to 4294967295. The default is 0.

Enabling IRDP Globally

To enable IRDP globally, enter the following command:
HPswitch(config)# ip irdp
This command enables IRDP on the IP interfaces on all ports. Each port uses
the default values for the IRDP parameters.

Enabling IRDP on an Individual VLAN Interface

To enable IRDP on an individual VLAN interface and configure IRDP param­
eters, enter commands such as the following:
HPswitch(config)# vlan 1
HPswitch(vlan-1)# ip irdp maxadvertinterval 400
This example shows how to enable IRDP on a specific interface (VLAN 1) and
change the maximum advertisement interval for Router Advertisement
messages to 400 seconds.
IP Routing Features
Configuring IRDP
16-19