Enabling Irdp Globally; Enabling Irdp On An Individual Vlan Interface - HP ProCurve 5300xl Series Management Manual

messages from other routers at the same time. The interval on each IRDP-
enabled routing switch interface is independent of the interval on other
IRDP-enabled interfaces. The default maximum message interval is 600
seconds. The default minimum message interval is 450 seconds.
■ Preference - If a host receives multiple Router Advertisement messages
from different routers, the host selects the router that send the message
with the highest preference as the default gateway. The preference can be
a number from -4294967296 to 4294967295. The default is 0.

Enabling IRDP Globally

To enable IRDP globally, enter the following command:
HP(config)# ip irdp
This command enables IRDP on the IP interfaces on all ports. Each port uses
the default values for the IRDP parameters.

Enabling IRDP on an Individual VLAN Interface

To enable IRDP on an individual VLAN interface and configure IRDP param­
eters, enter commands such as the following:
HP(config)# vlan 1
HP(vlan-1)# ip irdp maxadvertinterval 400
This example shows how to enable IRDP on a specific interface (VLAN 1) and
change the maximum advertisement interval for Router Advertisement
messages to 400 seconds.
Syntax: [no] ip irdp [broadcast | multicast] [holdtime <seconds>] [maxadvertinterval
< seconds >] [minadvertinterval < seconds >] [preference < number >]
broadcast | multicast - This parameter specifies the packet type the routing
■
switch uses to send the Router Advertisement.
broadcast - The routing switch sends Router Advertisements as IP
•
broadcasts.
• multicast - The routing switch sends Router Advertisements as multi-
cast packets addressed to IP multicast group 224.0.0.1. This is the
default.
holdtime < seconds > - This parameter specifies how long a host that
■
receives a Router Advertisement from the routing switch should consider
the advertisement to be valid. When a host receives a new Router Adver­
tisement message from the routing switch, the host resets the hold time
IP Routing Features
Configuring IRDP
11-71