Figure 7-3. Example of Executing the Console Command with Multiple Parameters
Configure
the
individual
parameters.
Save the
changes.
Boot the
switch.
Figure 7-4. Example of Executing a Series of Console Commands
VT100 operation
■
■
19,200 baud
■
No flow control
10-minute inactivity time
■
■
Critical log events
you would use the following command sequence:
The switch implements the Event Log change immediately. The switch implements
the other console changes after executing
You can also execute a series of console commands and then save the
configuration and boot the switch. For example:
Interface Access, System Information, and Friendly Port Names
Interface Access: Console/Serial Link, Web, and Telnet
write memory
reload
and
.
7-7