HP ProCurve Series 4100GL Management And Configuration Manual page 403

Remove this Member
from the stack.
Figure 15-34. Example of a Commander and Three Switches in a Stack
CLI for "North Sea"
Stack Member
MAC Address of the
Commander for the
Stack to Which
the"North Sea"
Switch Belongs
Figure 15-35. Example of How To Identify the Commander's MAC Address from a Member Switch
Use show stack view to list the stack Members. For example, suppose that you
wanted to use the Commander to remove the "North Sea" Member from the
following stack:
You would then execute this command to remove the "North Sea" switch from
the stack:
HPswitch(config)# no stack member 3 mac-address 0030c1-
7fc700
where:
• 3 is the "North Sea" Member's switch number (
• is the "North Sea" Member's MAC address
0030c1-7fc700
Using the Member's CLI To Remove the Member from a Stack.
Syntax: no stack join <mac-addr>
To use this method, you need the Commander's MAC address, which is
available using the show stack command in the Member's CLI. For example:
You would then execute this command in the "North Sea" switch's CLI to
remove the switch from the stack:
HP ProCurve Stack Management
Configuring Stack Management
SN )
15-41