server, ensure that the server's Syslog application is configured to accept
the "debug" severity level. (The default configuration for some Syslog
applications ignores the "debug" severity level.)
■
A reboot temporarily suspends Syslog logging. After a reboot, the
switch suspends configured Syslog logging for 30 seconds.
Diagnostic Tools
Diagnostic Features
Feature
Port Autonegotiation
Ping Test
Link Test
Display Config File
Admin. and Troubleshooting
Commands
Factory-Default Config
Port Status
Port Auto-Negotiation
When a link LED does not light (indicating loss of link between two devices),
the most common reason is a failure of port auto-negotiation between the
connecting ports. If a link LED fails to light when you connect the switch to a
port on another device, do the following:
1.
Ensure that the switch port and the port on the attached end-node are
both set to Auto mode.
2.
If the attached end-node does not have an Auto mode setting, then you
must manually configure the switch port to the same setting as the end-
node port. See Chapter 10, "Optimizing Traffic Flow with Port Controls,
Port Trunking, and Port-Based Priority".
Default
Menu
n/a
n/a
n/a
—
n/a
—
n/a
—
n/a
—
page C-40
—
(Buttons)
n/a
pages B-8
and B-9
Troubleshooting
Diagnostic Tools
CLI
Web
n/a
n/a
page C-34
page C-33
page C-34
page C-33
page C-36
page C-36
page C-39
—
page C-40
—
pages B-8
pages B-8
and B-9
and B-9
C-31