HP ProCurve Series 4100GL Management And Configuration Manual page 56

Using the Command Line Interface (CLI)
Using the CLI
Table 4-1. Privilege Level Hierarchy
Privilege Example of Prompt and Permitted Operations
Level
Operator Privilege
Operator
HPswitch>
Level
Manager Privilege
Manager
HPswitch#
Level
Global
HPswitch(config)#
Configuration
Level
Context
HPswitch(eth-5)#
Configuration HPswitch(vlan-100)#
Level
4-6
Changing Interfaces. If you change from the CLI to the menu interface, or
the reverse, you will remain at the same privilege level. For example, entering
the menu command from the Operator level of the CLI takes you to the
Operator privilege level in the menu interface.
show < command >
setup
ping < argument >
link-test < argument >
enable
menu
logout
exit
Perform system-level actions such as system control, monitoring,
and diagnostic commands, plus any of the Operator-level
commands. For a list of available commands, enter ? at the
prompt.
Execute configuration commands, plus all Operator and Manager
commands . For a list of available commands, enter ? at the
prompt.
Execute context-specific configuration commands, such as a
particular VLAN or switch port. This is useful for shortening the
command strings you type, and for entering a series of commands
for the same context. For a list of available commands, enter ? at
the prompt.
View status and configuration
information.
Perform connectivity tests.
Move from the Operator level to the
Manager level.
Move from the CLI interface to the menu
interface.
Exit from the CLI interface and terminate
the console session.
Terminate the current session (same as
logout).