Cli: Configuring Vlan Parameters - HP ProCurve Series 4100GL Management And Configuration Manual

Ports A4 and A5 are
assigned to both
VLANs.
Ports A6 and A7 are
assigned only to
VLAN-22.
All other ports are
assigned only to the
Default VLAN.
Figure 12-10. Example of VLAN Assignments for Specific Ports
3.

CLI: Configuring VLAN Parameters

In the factory default state, all ports on the switch belong to the default VLAN
(DEFAULT_VLAN) and are in the same broadcast/multicast domain. (The
default VLAN is also the default primary VLAN—see "The Primary VLAN" on
page 12-6.) You can configure up to 29 additional static VLANs by adding new
VLAN names, and then assigning one or more ports to each VLAN. (The switch
accepts a maximum of 30 VLANs, including the default VLAN and any dynamic
VLANs the switch creates if you enable GVRP—page 12-33.) Note that each
port can be assigned to multiple VLANs by using VLAN tagging. (See "VLAN
Tagging Information" on page 12-22.)
For information on VLAN tags ("Untagged" and "Tagged"), refer to
"VLAN Tagging Information" on page 12-22.
d. If you are finished assigning ports to VLANs, press
(for Save) to activate the changes you've made and to return to the
Configuration menu. (The console then returns to the VLAN menu.)
Return to the Main menu.
Port-Based Virtual LANs (VLANs) and GVRP
Port-Based Virtual LANs (Static VLANs)
[Enter]
and then
[S]
12-15