Displaying Irdp Information - HP ProCurve Series 4100GL Management And Configuration Manual

HPswitch# show ip irdp
Status and Counters - ICMP Router Discovery Protocol
Globa l Status : Disabled
VLAN Name Status
----- --------- -------- ------------ ------- ------- --------
DEFAU LT_VLAN Enable d
VLAN2 0 Enable d
VLAN3 0 Enable d
Figure 16-3. Example of Displaying IRDP Information
[ minadvertinterval < seconds > ]
This parameter specifies the minimum amount of time the
routing switch can wait between sending Router
Advertisements. Default: three-fourths (0.75) the value of the
maxadvertinterval parameter.
If you change the maxadvertinterval parameter, the software
automatically adjusts the minadvertinterval parameter to be
three-fourths the new value of the maxadvertinterval
parameter. If you want to override the automatically
configured value, you can specify an interval from 1 to the
current value of the maxadvertinterval parameter.
[preference < number >]
This parameter specifies the IRDP preference level of this
routing switch. If a host receives Router Advertisements from
multiple routers, the host selects the router interface that sent
the message with the highest preference as the host's default
gateway. The valid range is -4294967296 to 4294967295.
Default: 0.

Displaying IRDP Information

To display IRDP information, enter the following command from any CLI level:
Adver tising
Add ress
multicast
multicast
multicast
Min int Max int Holdtime Preference
(sec) (sec) (sec)
450 600 1800
450 600 1800
450 600 1800
IP Routing Features
Configuring IRDP
-----------
0
0
0
16-21