Ametek 2003RP User And Programming Manual page 10

List of Tables
Table 1-1: Available models .................................................................................................................. 1
Table 3-1: Maximum Output Wiring Lengths ...................................................................................... 19
Table 4-1: Factory Default Power on Settings .................................................................................... 31
Table 6-1: Load Resistors and Current .............................................................................................. 42
Table 6-2: CAL Mode Status LED Indicators ..................................................................................... 43
Table 7-1: Basic Symptoms ............................................................................................................... 52
Table 7-2: Poor Output Voltage Accuracy .......................................................................................... 52
Table 7-3: Poor Output Voltage Regulation ....................................................................................... 53
Table 7-4: Distorted Output ................................................................................................................ 53
Table 7-5: Unit Shuts Down After 3-5 Seconds ................................................................................. 53
Table 7-6: No Output and No Lights on Front Panel .......................................................................... 53
Table 7-7: No Output But "Display" Is On ......................................................................................... 54
Table 7-8: Replaceable Parts ............................................................................................................. 58
Table 7-9: Fuses ................................................................................................................................ 59
Table 10-1: Mode Command Encoding ............................................................................................. 97
Table 10-2: Bit Configuration of Standard Event Status Enable Register ........................................ 101
Table 10-3: Bit Configuration of Standard Event Status Register .................................................... 102
Table 10-4: *RST Default Parameter Values ................................................................................... 104
Table 10-5: Status Registers - Power on Conditions ........................................................................ 104
Table 10-6: Bit Configuration of Status Byte Register ...................................................................... 105
Table 12-1: Bus Error Messages ..................................................................................................... 115