Ametek 2003RP User And Programming Manual page 98

[SOURce:]FREQuency
This command sets the frequency of the output sinewave.
Command Syntax
Parameters
Unit
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
[SOURce:]VOLTage
This command programs the AC rms output voltage level of the power source. The
maximum voltage value allowed is determined by the selected voltage range. For 2003RP-
AV models configured for single voltage range, only one range is available.
Command Syntax
Parameters
Unit
*RST Value
Examples
Query Syntax
Returned Parameters
Related Commands
[SOURce:]FREQuency <NRf>
range specified by the LIM:FREQ:LOW and LIM:FREQ:HIGH
commands
Hz (Hertz)
defined by PON
FREQ 50
FREQuency?
<NR2>
LIM:FREQ;LOW? LIM:FREQ:HIGH?
[SOURce:]VOLTage[:LEVel] <NRf>
0 to maximum voltage range specified by the VRAN command
V (rms voltage)
0 volt
VOLT 250 VOLT:LEV 25
[SOURce:]VOLTage[:LEVel]?
<NR2>
VOLT:RANGe