Operational Safety - Fuji Xerox DocuPrint CM405 df User Manual

Operational Safety

WARNING
The operator's product maintenance procedures are described in the customer documentation supplied with
this product. Do not carry out any other maintenance procedures not described in the documentation.
This product features safety design not to allow operators access to hazard areas. The hazard areas are
isolated from operators by covers or protectors which require a tool to remove. To prevent electric shock and
injuries, never remove those covers and protectors.
To avoid the risk of electric shock and a fire accident, switch off and unplug the product promptly in the
following conditions, then contact your local Fuji Xerox representative.
• The product emits smoke or its surface is unusually hot.
• The product emits unusual noise or odor.
• The power cord is cracked or worn down.
• A circuit breaker, fuse or any other safety device becomes activated.
• Any liquid is spilled into the product.
• The product is soaked in water.
• Any part of the product is damaged.
Do not insert any object into slots or openings of this product.
Do not put any of the followings on the product:
• Liquid container such as flower vases or coffee cups
• Metal parts such as staples or clips
• Heavy objects
If liquid is spilled over or metal parts are slipped into the product, it may cause electric shock or a fire accident.
Do not use conductive paper such as origami paper, carbonic paper or conductively-coated paper. When
paper jam occurs, it may cause short-circuit and eventually a fire accident.
When cleaning this product, use the designated cleaning materials exclusive to it. Other cleaning materials
may result in poor performance of the product. Never use aerosol cleaners to avoid catching fire and
explosion.
Never play the CD-ROM supplied with the product on an audio player. Always use a CD-ROM player.
Otherwise, large sound may damage audio players or your ears.
Laser Safety
CAUTION:
• Any operations or adjustments not stated in the operation manual may cause hazardous light
exposure and eventually burn injuries or loss of eyesight.
This product has been tested and found to comply with the Class 1 Laser Equipment requirements defined by
the international standard IEC60825 and has no light exposure hazard. The product has no hazardous light
emission as it features light protection components and covers to shut in all light beam during operation and
maintenance.
CAUTION
Always follow all warning instructions marked on or supplied with this product.
To avoid the risk of burn injuries and electric shock, never touch the area with the "High Temperature" or "High
Voltage" marks on.
Keep electrical and mechanical safety interlocks active. Keep the safety interlocks away from magnetic
materials. Magnetic materials may accidentally activate the product and cause injuries or electric shock.
Do not attempt to remove a paper deeply jammed inside the product, particularly a paper wrapped around the
fusing unit or the heat roller. Otherwise, it may cause injuries or burns. Switch off the product immediately and
contact your local Fuji Xerox representative.
20
Safety Notes