Procedures For Printing Stored Print - Fuji Xerox DocuPrint CM405 df User Manual

Procedures for Printing Stored Print

The following are procedures for storing and printing jobs.
• Storing Print Jobs
For Secure Print, select Secure Print for Job Type and specify the user ID, passcode and job name by clicking
Setup in the Paper/Output tab of the print driver. When you send the job to the printer, the job will be stored in the
memory until you request to print from the operator panel or turn off the printer, or in the hard disk until you request
to print it from the operator panel.
For Sample Print, select Sample Set for Job Type and specify the user ID and job name by clicking Setup in the
Paper/Output tab of the print driver. When you send the job to the printer, the first set is printed. The remaining
copies will be stored in the memory until you select to print them on the operator panel or turn off the printer, or in the
hard disk until you select to print them on the operator panel.
NOTE:
• If a print job is too large for the memory or hard disk available, the printer may display error messages.
• If a document name is not assigned to your print job in the print driver, the job's name will be identified using the printer's time
and date of submission to distinguish it from other jobs you have stored under your name.
• Printing the Stored Jobs
Once jobs are stored, you can use the operator panel to specify printing.
Printing the Secure Print Job
Secure Print requires the passcode you specified in the driver when you sent the job.
To print the Secure Print jobs, use the procedure below.
1
Press the (Job Status) button.
2
Select Secure Print.
3
Select a user ID you specified in the print driver.
4
Enter the passcode you specified in the print driver using the number pad, and select OK.
For details about specifying the passcode, see
Print)" on page 162.
5
Select the document you want to print.
NOTE:
• By default, the driver setting is used for the number of copies to print. You can select Quantity to change the setting.
6
Select Print.
NOTE:
• If you want to delete the data in the memory or hard disk after printing, select the Print and Delete check box.
7
Select OK.
The stored document will be printed.
Printing the Sample Print Job
To print the Sample Print jobs, use the procedure below.
1
Press the (Services) button.
"Specifying Your Passcode on the Operator Panel (Secure
161
Printing Basics