Operational Safety - Fuji Xerox ApeosPort-V 4020 Quick Reference

1 Before Using the Machine

Operational Safety

1
14
The operator's product maintenance procedures are described in the
customer documentation supplied with this product. Do not carry out any
other maintenance procedures not described in the documentation.
This product features safety design not to allow operators access to hazard
areas. The hazard areas are isolated from operators by covers or protectors
which require a tool to remove. To prevent electric shock and injuries, never
remove those covers and protectors.
To avoid the risk of electric shock and a fire accident, switch off and unplug
the product promptly in the following conditions, then contact Fuji Xerox
Customer Support Center.
The product emits smoke or its surface is unusually hot.

 The product emits unusual noise or odor.
 The power cord is cracked or worn down.
 A circuit breaker, fuse or any other safety device becomes activated.
 Any liquid is spilled into the product.
The product is soaked in water.

 Any part of the product is damaged.
Do not insert any object into slots or openings of this product.
Do not put any of the followings on the product:
Liquid container such as flower vases or coffee cups

 Metal parts such as staples or clips
Heavy objects

If liquid is spilled over or metal parts are slipped into the product, it may
cause electric shock or a fire accident.
Do not use conductive paper such as origami paper, carbonic paper or
conductively-coated paper. When paper jam occurs, it may cause short-
circuit and eventually a fire accident.
When cleaning this product, use the designated cleaning materials exclusive
to it. Other cleaning materials may result in poor performance of the
product. Never use aerosol cleaners to avoid catching fire and explosion.
When you play the media (e.g., CD-ROM, DVD) supplied with the product,
always use said media-enabled device. Otherwise, large sound may damage
its speakers or your ears.
Laser Safety
CAUTION: Any operations or adjustments not stated in the operation
manual may cause hazardous light exposure and eventually burn injuries or
loss of eyesight.
This product has been tested and found to comply with the Class 1 Laser
Equipment requirements defined by the international standard IEC60825
and has no light exposure hazard. The product has no hazardous light
emission as it features light protection components and covers to shut in all
light beam during operation and maintenance.