Port Security Commands - D-Link DGS-3224TGR Command Line Interface Reference Manual

The port security commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config
port_security
delete
port_security_entry
clear
port_security_entry
show port_security
Each command is listed, in detail, in the following sections.
config port_security
Purpose Used to configure port security.
Syntax ports [ <portlist>| all ] {admin_state [enable |
disable]max_learning_addr<max_lock_no 0-10>|lock_address_mode [permanent|
deleteontimeout|deleteonreset]}
Description This command allows you to configure port security, including admin state, maximum
learning address, and lock address mode.
<portlist> − Specifies a range of ports to be configured.
Parameters
all − Instructs all ports to be configured.
admin_state − Allows the port security to be enabled or disabled for the ports specified in the
port list.
max_learning_addr − The maximum number of addresses that can be learned.
lock_address_mode − Indicates the mode of locking address. Three choices are offered:
Permanent − Indicates the locked addresses will not age out, even when the system is
rebooted. These locked addresses can be deleted when the system is reset.
DeleteOnTimeout − Indicates the locked addresses can be aged out after the aging timer
expires.
DeleteOnReset − Indicates never age out the locked addresses unless the system is
rebooted or reset in order to prevent port movement or intrusion.
DGS-3224TGR Gigabit Ethernet Switch CLI Reference Manual
P
ORT
Parameters
ports [ <portlist>| all ] {admin_state [enable |
disable]max_learning_addr<max_lock_no 0-10>|lock_address_mode [permanent|
deleteontimeout|deleteonreset]}
vlan_name <vlan_name 32> mac_address <macaddr> port <port>
port <portlist>
{ports <portlist>}
S
ECURITY
71
15
C
OMMANDS